STM32F103 basic peripheral initialization - Eclipse IDE

$30-250 USD

Completed

Posted

over 8 years ago

$30-250 USD

Paid on delivery

Hello! Need basic initialization for stm32 peripheral. PLL 72MHz from 8MHz Clock Timers IRQ Tick 10KHz SPI Master Mode DMA Operation 20MHz for EEPROM & Ethernet I2C Master Mode DMA Operation 400KHz for RTC PWM 20KHz, 38KHz for infrared reciever UART TX/RX 115Kbps TX_Debug/RX_Debug 115Kbps ADC DMA Scan Mode Operation 1MHz USB Polling in Mainloop Enumerate as MSD, scan for Hex files USB Bootloader Firmware Upgrade I/O LED GREEN Output 0.5HZ Toggle LED RED Output 10KHz Toggle

C++ Programming

Electronics

Microcontroller

Project ID: 8667370

About the project

9 proposals

Remote project

Active 9 yrs ago

Looking to make some money?

Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

Get paid for your work

Outline your proposal

It's free to sign up and bid on jobs

Awarded to:

@strelecxii

Hi, I am an expert with stm32 microcontrollers and most of the project that I have worked on were including this type of microcontroller. Have on my side stm32f4 discovery, stm32f3 discovery and stm32 nucleo with stm32f030r8t6. For developing I am using CooCox IDE which is Eclipse based. Will do this job for minimal payment because I am new to freelancer. Thank you for reading my application. BR, Dean

$32 USD in 3 days

5.0

(1 review)

1.0

9 freelancers are bidding on average $160 USD for this job

@viniciusfre

Hello, I work with embedded systems and C programming since 2009 and I have experience with PIC and ARM microcontrollers. I have worked with ARM microcontrollers such as ST, NXP and Texas.

$222 USD in 30 days

5.0

(11 reviews)

4.9

@htr1000

I'm electronic and telecommunication engineer and I can do the job. .

$277 USD in 10 days

5.0

(10 reviews)

4.3

@VenuVasam

Hi, I can deliver complete project (schematic, firmware ) with best quality. I've excellent knowledge on embedded systems design from component selection to the documentation including electronic circuit design, firmware/software development, maintenance etc .. Also I'm happy to provide you after delivery support for any clarifications or upgrades. Looking forward to work with you Thanks and kind regards, Venu

$222 USD in 3 days