Need to fix boot issue of Juniper SRX340 Firewall

Getting some errors with my Juniper SRX340 after a power outage. It showing the following error after starting:

------------------------------------------------------

U-Boot 2013.07-JNPR-3.1 (Build time: May 03 2016 - 23:50:19)

Using DRAM size from environment: 4096 MBytes

checkboard siege

SATA0: not available

SATA1: not available

SATA BIST STATUS = 0x0

SRX_340 board revision major:1, minor:6, serial #: CY2516AF0102

OCTEON CN7130-AAP pass 1.2, Core clock: 1200 MHz, IO clock: 600 MHz, DDR clock: 667 MHz (1334 Mhz DDR)

Base DRAM address used by u-boot: 0x10f000000, size: 0x1000000

DRAM: 4 GiB

Clearing DRAM...... done

SF: Detected MX25L6405D with page size 256 Bytes, erase size 64 KiB, total 8 MiB

PCIe: Port 0 link active, 1 lanes, speed gen2

PCIe: Link timeout on port 1, probably the slot is empty

PCIe: Port 2 not in PCIe mode, skipping

Net: octrgmii0

octeon_fdt_broadcom_config: Unknown broadcom phy for octrgmii0

Interface 4 has 1 ports (AGL)

Type the command 'usb start' to scan for USB storage devices.

Boot Media: eUSB usb

Found TPM SLB9660 TT 1.2 by Infineon

TPM initialized

Hit any key to stop autoboot: 0

SF: Detected MX25L6405D with page size 256 Bytes, erase size 64 KiB, total 8 MiB

SF: 1048576 bytes @ 0x200000 Read: OK

## No elf image at address 0x00100000

Octeon srx_340_ram#

------------------------------------------------------

I will give you Anydesk access to fix error. No USB media is connected with the device. Only TFTP is configured for data transfer.

Juniper

Project ID: #36376289

About the project