Initial Project phase - Advice and Plan - Sub GHz RF Data Link Design for ISM band SRD Radio Control IoT

Closed Posted 5 years ago Paid on delivery
Closed Paid on delivery

Please read this requirement in order to correctly post a bid for this project.

This initial project is to define the method and plan for development of a sub GHz RF Data Link Design for ISM band SRD Radio Control IoT.

I would like advice from an engineer who has experience with RF chip sets and modules in the 433MHz, 868MHz and 915MHz ISM bands. Also experience of the radio regulations which must be met to certify the product in Europe, USA, Australia, South Korea and more.

The successful applicant is bidding to write a project plan detailing:

1) The Required radio parameters to be met for the 4 listed countries (power, bandwidth, hopping, on air duty cycle, spurious emissions etc)

2) A suggested chip set or module with reasons (advantages, disadvantages)

3) Alternative suggestions to be considered.

4) Approximate development time and cost expectation.

In order to demonstrate understanding and be considered for this task, applicants should detail the following points in their proposal:

1) Their experience with similar projects

2) A couple of suggested RF chip / module solutions that should be looked at during the project

3) Describe why South Korea may require a different solution

(If you can fulfill part of the requirement but not all, please specify which parts you can achieve and bid appropriately)

A following project will be posted to help develop the Radio Data Link.

Radio Data Link Requirement:

Good Range (100m open air)

Simple and Reliable Half Duplex data link.

Low Cost.

Low Data Rate. Approximately 9.6 kBaud (at least 1.5 kBaud required)

As few model variations as possible between countries.

The design may me included on a main board or built as a module to plug into a main board.

Thanks for reading.

Kind Regards,

TecAttic

Electrical Engineering Electronics Engineering Microcontroller PCB Layout

Project ID: #17792171

About the project

2 proposals Remote project Active 5 years ago

2 freelancers are bidding on average £186 for this job

ArtShidlovskiy

A more extensive description of the project is needed. In general, everything is clear, but there are questions. The size of the printed circuit board, the antenna built-in or an external source of power or the battery More

£222 GBP in 10 days
(4 Reviews)
4.8
nick315

I have experience in micro controller programming in C and interfacing with external devices. The RF module previously works with which operated on ISM band and communicated with controller on Serial link. The part wa More

£150 GBP in 4 days
(3 Reviews)
2.4