I am an electrical engineer that has designed a flow sensor 0 to .5 LPM. It uses a PIC24F16KL402., a ATBTLC BLE module, and has two 256K EEPROMs. Tiny board, (1 inch x 1.5 inch) uses a 13 pin pogo probe interface. It has a micro B USB. It has a non-linear flow sensor as well as a 128 x 32 graphics screen. I have gone to the extent of my abilities programming this, (actually, I am using a Arduino Mega to interface with it and have been working on the interface mostly) but I do have bitmaps for what I'd like an a general idea of what everything would look like. Naturally, I am behind. Unless there are huge errors, I don't want to radically change anything on the board unless absolutely necessary (like as if it doesn't work, obvs.) I would like to send you a rough sketch of what I need and get a partial deliverable, then correct it and iterate until I am happy. If you can work like that, please let me know.
17 freelancers are bidding on average $36/hour for this job
I am professional embedded software engineer. I have worked on Arduino and iot based project. Professionally worked on PIC18 and PIC24 processor for more than 3 years.. I can finish project before deadline.
Hello, I am an electronics engineer with over ten years of software development experience. Could you send me more information? Any schematics, images etc. And how will I have access to the hardware? Regards