Make intake air pump with arduino
$250-750 USD
Paid on delivery
I have just normal air pump. The air pump with remote controller. In remote controller exist just only two button. Buttons are on/off. When press on button Air pump is working until stop (maximum air pumping). After finish pumping the air is maintain with high air pressure. When press off button the pumped air are release so air pressure is gone. The remote controller provide 2. But they are definitely same function (They provide remote controller for prepare lost). But what I want is Just let function 1 remote controller (It can be replace arduino but function (on/off) should be same) and another 1 remote controller Off button is same, But when press On button I want to change it just air pumping few time (5~10% of maximum air pumping range). In additional When air pumping the pumping we can hear pumping sound. Then 1 remote controller (original) is make sound 10 seconds. Because original remote controller is full air pumping until maximum. But another 1 remote controller we remodeling on button is just 5~10% pumping in maximum range. Then with second remote controller pumping sound is only 1~2 seconds. Do you understand? What I want is fake someone. So we make it same design and same size remote controller. But different function ON button. So I want to make pumping sound decibel and sound duration. We can make buzzer or something for fake pumping sound. If you have more questions or not understand part please tell me.
<Original air pump>
A remote controller : On is intake air until stop (air pressor sensor or just stop for maximum zip air idk well) / Off: release all ziped air with open the air valve
B remote controller : On is intake air until stop (air pressor sensor or just stop for maximum zip air idk well) / Off: release all ziped air with open the air valve
------------------------------------------------------------------
<After remodeling>
A remote controller : On is intake air until stop (air pressor sensor or just stop for maximum zip air idk well) / Off: release all ziped air with open the air valve
B remote controller : On is intake air just little(5% of original maximum intake) but air pumping sound is same with Original controller (decibel and duration of sounds) = little pumping but make fake pumping sound for make it look like working normally well
Also you can check photos. I was attached. The important is air pump is not make air. They are intake the air and make it zip.
Project ID: #29969201
About the project
9 freelancers are bidding on average $533 for this job
Hi, I am an electronic engineer with more than 10 years of experience. I can work with you on this remotely and help you set things up. We can use a recorded sound from the original pump to fake it from the second remo More
Hi, I am a electronics and communication engineer with more than 2 years of experience in this field. I have worked on many projects related to this in past. So I have a good knowledge and experience that can help me More
hello sir, how are you. I read your proposal and i am interested in this project. I am an Embedded engineer (ARM, PIC, AVR, Arduino, SOC BLE (bluetooth) chips, ZigBee, WiFi, GPS, LED, LCD display etc.) and PCB designe More
Hello there. I have read your project details and help you.. I have 4 years of PCB experience and 3 years of firmware exerience, so can handle this project.. I can make firmware using keil/IAR/Visual Studio.. Hope more More
Dear Sir, Easy Task!!! You want to make a one sample or you want to make a lot? If you want to make one we can use Arduino. And if you want a lot we can use another low cost micro-controller. And I can design th PC More
Dear Sir, I have experience in providing complete embedded solutions for 3years. I am skilled in programming microcontrollers like Renesas, Texas Instruments, PIC, Arduino, Espressif, and many more. I can design schema More