Antenna Design Jobs

ESP32 Sonar Data Streaming to Android Phone – 300–400m Direct Wi-Fi Link, No Repeater I am looking for an experienced embedded/RF developer to build a reliable wireless communication system for a fishing boat sonar. CURRENT SETUP On the boat: - Sonar - Existing sonar driver - ESP32 On shore: - Android phone WHAT I NEED I want the following architecture: DRIVER → ESP32 → Wi-Fi AP + external antenna → 300–400m → Android phone → APK The Android phone must connect DIRECTLY to the boat. STRICT REQUIREMENTS - 350–450 meters real-world range - Direct boat → phone connection - NO repeater - NO router/access point on shore - NO additional radio receiver on shore - NO internet connection required - Android phone must receive the data di...

I need a complete high-frequency RF PCB laid out in KiCad for a signal-processing application. The board must integrate antennas directly on the substrate; no filters or discrete amplifiers are planned at this stage, so every trace, via, and ground return has to be optimized for clean, low-loss feed to the antenna structure. Scope • Translate my existing schematic (KiCad format) into a production-ready multilayer layout. • Model and route all RF paths with controlled impedance, proper stack-up definition, and tight clearance to meet high-frequency performance targets. • Design and tune the on-board antenna geometry, matching network, and keep-out regions inside KiCad’s PCB editor and 3D viewer. • Run DRC, ERC, and any KiCad integrated RF simulation tools ...

We are looking for an experienced RF PCB Layout Engineer to review and complete an existing multi-radio PCB design. This is not a design-from-scratch project. The schematic, component placement and most signal/power routing are already completed. The remaining work is focused mainly on RF layout finalization and production-readiness review. Required experience: Sub-GHz / LoRa RF PCB routing LTE RF layout GNSS RF layout 50-ohm controlled-impedance routing RF matching networks antenna feed layout ground return and stitching-via strategy RF keep-outs and isolation multilayer PCB stack-up EMI/EMC-aware layout KiCad The selected engineer will be required to review the existing PCB, complete/correct the RF sections and bring the board to fabrication-ready status. Expected deliverables incl...