Spi programmer software jobs

Filter

My recent searches
Filter by:
Budget
to
to
to
Skills
Languages
    Job State
    1,082 spi programmer software jobs found, pricing in USD

    ...for Simple Vlook-up Quick & Simple NEEDS to be done now! I have SKU in Column A and the Price in Column C (2018 Dealer List) I need you to Fill in Column I from Document 2 (SPI Template) with the correct price (in correlation with Column C 2018 Dealer List). Please note not all items are here for column E if it is blank leave it blank or N/A. Thanks

    $27 (Avg Bid)
    $27 Avg Bid
    10 bids

    I need you to develop some software for me. I would like this software to be developed using C or C++. Software setup/config/development for Atmel SAMW25 and SAME70 microcontrollers using atmel Studio 7. One program for each microcontroller type, two programs in total. Creating the base application, configure the pins, include relevant frameworks

    $1412 (Avg Bid)
    $1412 Avg Bid
    12 bids

    ...implementation is using FWR mode for impedance measurement. Will change over to IQ mode make any difference? 3. For a constant resistor value, it would be a good idea to scope the SPI interface (DOUT) and check if the readings are reasonably stable 4. Since the body impedance measurements should not change much, it would help to get them to run the ADC at

    $376 (Avg Bid)
    $376 Avg Bid
    4 bids

    ...project include ATmega328p and SDcard with audio file on it. The Atmega can read and play sound on the SD Card, that work well. But now I would like to replace the SD card by a SPI Flash, and add a USB connectivity for access to the flash from a computer and give access to change the sound file on the flash through the windows explorator file (like with

    $29 (Avg Bid)
    $29 Avg Bid
    4 bids

    I need non-blocking WiFi, SPI and I2C libraries written for this board specifically: [url removed, login to view] (Adafruit Feather M0 WiFi - ATSAMD21 + ATWINC1500) If you do not have or cannot get one to develop with (on your own) please do not apply.

    $663 (Avg Bid)
    $663 Avg Bid
    11 bids

    Need someone to translate meeting notes for a corporate meeting in Greensboro, NC

    $20 / hr (Avg Bid)
    $20 / hr Avg Bid
    7 bids

    I want someone to design atmega328p based pcb with USB , programming , k-type thermocouple , Max6675, arduino programming pins , W25Q128FVSSIG - 16MB SPI Flash. Milestone based project , lowest bidder will be prefered. details will be discussed later. Thanks

    $80 (Avg Bid)
    $80 Avg Bid
    15 bids

    ...Experience with Squid is preferable but if not possible I have attached some relevant links so that you can gain a greater understanding. [url removed, login to view] [url removed, login to view] [url removed, login to view] Thank

    $46 (Avg Bid)
    $46 Avg Bid
    4 bids

    The project has to be done only whith Eagle CAD software ([url removed, login to view]). Components should be on one side of the pcb. The purpose of this project is to design a PCB board with a Rasperry Pi 2/3 witch include the UPS Hat Board : - board has to fit Standard DIN rail mounting enclosure - 12v/24v power supply with

    $103 (Avg Bid)
    $103 Avg Bid
    3 bids

    Looking for someone to bring up the OLED that SPI interface.

    $109 (Avg Bid)
    $109 Avg Bid
    13 bids

    ...product is based upon and the two systems communicate over SPI - the host system can be slow. We have a poorly written version working in an existing product that we want rewritten with good code not riddled with timer loops and spaghetti hacks. The project should take 4 to 6 weeks and hired programmer will have both access to the hardware as well as our

    $9330 (Avg Bid)
    $9330 Avg Bid
    7 bids

    Looking for someone with over 10+ years experience in Device Driver development. The protocols/drivers include SPI, I2C, HDMI, SDI, LED/OLEDs. Preference on NVIDIA boards.

    $484 (Avg Bid)
    $484 Avg Bid
    9 bids

    ...with an ILI9488 controlled TFT LCD. The driving will be using an FPGA in raw video mode (Vsync, Hsync + 16bits bus + clk) however additional interfacing is required through SPI for gamma correction and other possible features. I need someone who can write up code for that and or assist in pointing out what code is required according to my demands. This

    $221 (Avg Bid)
    $221 Avg Bid
    6 bids

    ...setting up QT/C++/C application for BeagleboneBlack system (RevC). See here: [url removed, login to view] on BlackLib v3.0 C++ libraries for I2C, Serial, GPIO, PWM, SPI, etc. This is what I wanted to be the part of QT Creator IDE development for Begalbone Black. Plus, the QT libraries to be installed from here: [url removed, login to view]

    $558 (Avg Bid)
    Featured
    $558 Avg Bid
    15 bids

    ...following communication modules. - Wiznet 5500 - Ethernet Module - ESP8266 - Wifi Module - HM-19 Bluetooth Module - LoRa SX1278 - RF Module - Bootloader Implementation using spi flash as new firmware location. Compiler Required: IAR ARM V7.X Evaluation Board: Freedom Board for KL26Z (provided) Microcontroller: KL26Z128 This driver inits, config

    $250 (Avg Bid)
    $250 Avg Bid
    1 bids

    ...experienta in domeniu sunt sigur ca sunt lucruri de imbunatatit, chiar corectat. Pe scurt placa contine Bluetooth Low Energy, cativa senzori si circuite pe I2C, ADC extern pe SPI, circuit de on/off de la buton, circuit de incarcare baterie, boost 5V, LDO 3.3V etc. Totul este realizat in DipTrace, un tool gratis. Ca termen de finalitate ar fi saptamana

    $10 (Avg Bid)
    $10 Avg Bid
    1 bids
    Petalinux on ZC706 Ended
    VERIFIED

    I am looking for someone who has done work on Petalinux on ZC706 or Zedboard. The person MUST have done project...who has done work on Petalinux on ZC706 or Zedboard. The person MUST have done projects of Ethernet, PS Ram usage, external permanent memory storage using PCIe based drive, SPI control. I need to develop a project using above features.

    $166 (Avg Bid)
    $166 Avg Bid
    1 bids

    Hello, I need a atmega 328p (internal 8MHz clock) + nrf24l01 + SPI flash 32KB memory software to demonstrate a firmware update using flash. Require you to use [url removed, login to view] or simmilar. TODO: - create a working and tested demo software that will receive firmware update trough NRF, save it on the flash, and then reboot

    $196 (Avg Bid)
    $196 Avg Bid
    9 bids

    The TFT_eSPI lib [url removed, login to view] does not support ili9488 due to color mode. See issue below: [url removed, login to view] This project is to modify the above lib so that I can use ili9488 displays

    $257 (Avg Bid)
    $257 Avg Bid
    8 bids

    I would like to integrate two MAX31865 + RTD100 temperature sensors into a project of mine utilizing the GPIO SPI functionality. There are several bits of python code that illustrate the functionality of interfacing with the MAX31865. The node will need to read from the sensor, have inputs for each wire to list the GPIOs (cs_pin, clock_pin, data_in_pin

    $144 (Avg Bid)
    $144 Avg Bid
    11 bids